Floor Refinishing in Virginia

Sanding and refinishing for worn, scratched or dull wood floors, from a single room to a whole floor of an older house.

Book a measure

Gloved hands guiding an orbital floor sander across an oak floor that is half sanded and half old amber finish

About this service

A lot of the wood floors in older homes around here are far from finished with. Under the scratches, the gray paths by the doors and the old amber coating there is often solid oak or heart pine with years of life left. Refinishing brings that wood back without replacing a board.

We sand in passes, from coarse to fine, along the length of the boards, then work the edges and corners with smaller machines and hand scrapers. Dust is collected as we go and the baseboards are masked. Once the floor is bare and smooth, we can leave the natural tone of the wood or apply a stain, then build up the finish coats in the sheen you choose, from matte to satin to semi gloss.

Refinishing pairs well with small repairs. Split or stained boards can be replaced before sanding so the new pieces are sanded and coated together with the rest, and the patch disappears into the floor.

Plan for the rooms to be out of use for a few days. Sanding is the loud, dusty part and usually takes a day or two, while the finish coats need quiet time to set between them. Many people schedule refinishing around a weekend away, and we work out the order of the rooms so the rest of the house stays easy to use.

How the four stages run

  1. Measure

    We look at the boards, check how much wood is left above the tongue and talk about tone and sheen.

  2. Prepare

    Furniture moves out, trim is masked, loose boards are fastened and any damaged boards are swapped.

  3. Install

    The floor is sanded in passes, edges are detailed, and stain is applied if you chose one.

  4. Finish

    Finish coats are built up with light sanding between them, and the rooms rest before furniture returns.

Good to know

  • Most solid wood floors can be sanded several times
  • Sample patches of stain help you see the tone on your own boards
  • Matte and satin sheens hide small scratches better than gloss
  • Felt pads under furniture keep the new finish looking fresh

Questions people ask

How do I know if my floor can be refinished?

We pull a floor vent or look at a threshold to see how thick the wood is above the tongue. Solid floors usually have plenty. Some engineered floors have a thin top layer that allows only a light sanding, and we will tell you before you decide.

Can you change the color of my floor?

Yes. After sanding we can lay small test patches of two or three stain tones on your boards so you can see them in your own light before we commit to one.

How long before we can walk on the floor?

Light foot traffic in socks is usually fine a day after the last coat. Furniture and rugs wait a little longer. We give you the exact times for the finish we use on your floor.

Will the house fill with dust?

Our sanders collect most of the dust as they work, the rooms are closed off and the trim is masked. Some fine dust is normal, and we vacuum the floor and the rooms between every coat.

Planning floor refinishing?

Send the rooms and a few words about the floor today. We set up a measure and put the plan in writing.