Hardwood Floor Installation in Virginia

New solid or engineered wood floors for living rooms, bedrooms, dining rooms and halls, laid straight, diagonal or in herringbone.

Book a measure

Gloved hands setting a new red oak strip board into place with a rubber mallet and tapping block beside

About this service

A wood floor is the floor many older houses in this part of the state were built around, and it is still the one most people picture when they think of a finished room. We install solid strip and plank flooring as well as engineered boards with a real wood top layer, in oak, maple, hickory and walnut, prefinished or unfinished for sanding on site.

The work begins with the base. We check that the base is flat, firm and clean, add a layer of rosin paper or the underlayment your floor calls for, and let the boards rest inside the house before they go down. Rows are racked out ahead so color and grain spread evenly, joints are staggered, and a small gap is kept at every wall and hidden under the trim.

Straight lays are the most common, but a diagonal lay can make a narrow room look wider, and herringbone gives a dining room or entry the look of an old townhouse parlor. You can try each of these with our Plank lab before the visit and bring your favorite to the conversation.

How the four stages run

  1. Measure

    We measure every room, note door heights and floor transitions, and talk about species, width and pattern.

  2. Prepare

    Old covering is lifted, the base is flattened and fastened, and the boards rest in the house to settle.

  3. Install

    Boards are nailed or glued in the chosen pattern, with joints staggered and edges kept tight.

  4. Finish

    Baseboard and quarter round go back, thresholds are fitted, and unfinished floors are sanded and coated.

Good to know

  • Solid boards can be sanded several times over the life of the floor
  • Engineered boards stay calm over a slab or in rooms with a wide temperature swing
  • Wider boards show more grain, narrower strips suit older rooms
  • Herringbone takes more cutting time than a straight lay, so plan for an extra day

Questions people ask

Solid or engineered: which one should I pick?

Solid wood is one piece of timber top to bottom and can be refinished many times. Engineered boards have a real wood wear layer on a layered core, which keeps them more stable over a slab or in a sunroom. At the visit we look at the base and the room and explain which one fits.

Can new hardwood go over my old floor?

Sometimes. A flat, firmly attached older wood floor can serve as the base for new boards, as long as door heights still work. Carpet and pad always come up first, and soft or loose layers come out.

Why do the boards need to rest before the install?

Wood adjusts to the air in your home. Letting the bundles rest in the rooms for a few days means the boards have already settled before they are fastened, so seams stay tighter through the seasons.

Can you match the width of the floor in the next room?

In most cases, yes. Strip widths from the past are still made, and we can lace new boards into an existing floor so the two rooms read as one.

Planning hardwood floor installation?

Send the rooms and a few words about the floor today. We set up a measure and put the plan in writing.