A flooring material guide for Virginia homes

Wood tones, laying patterns, finishes and the main floor types we install, explained plainly so you can arrive at the measure with a clear idea.

Fan of floor samples in light oak, red oak, walnut and dark stain with a charcoal tile and a wool carpet square

Plank lab

Pick a tone and a laying pattern and the floor below redraws itself. When it looks right, carry the choice into your request and we will bring matching samples to the measure.

Floor preview: Natural, Straight
Tone
Pattern

Natural, Straight

The warm honey tone most older oak and pine floors have under their finish. A natural tone works with almost any trim color and suits both old houses and newer rooms.

Boards run parallel to the longest wall or toward the main window. The fastest lay and the one most older homes started with.

Use this in my request

Tones

Light oak
Pale, airy and modern. White oak with a clear or natural finish keeps rooms bright and shows the grain without much color. Scratches and dust show less than on dark floors.
Natural
The warm honey tone most older oak and pine floors have under their finish. A natural tone works with almost any trim color and suits both old houses and newer rooms.
Walnut
A rich, warm brown with deep grain. Walnut tones feel classic in parlors, dining rooms and studies, and look handsome next to painted trim and brick.
Dark
A deep espresso tone with a quiet, formal look. Dark floors make light walls and rugs stand out, and they show dust and pet hair a little sooner, so they suit calmer rooms.

Patterns

Straight
Boards run parallel to the longest wall or toward the main window. The fastest lay and the one most older homes started with.
Diagonal
Boards run at 45 degrees to the walls. A diagonal lay makes narrow rooms and halls feel wider and hides walls that are slightly out of square.
Herringbone
Short boards meet in a zigzag. The pattern of old townhouse parlors and entries, it takes more cutting time and rewards a room with a clear center.

Finish sheens

Matte
Low shine with a natural, almost unfinished look. Hides small scratches and dust most easily.
Satin
A soft glow without glare. The most popular sheen for living areas and bedrooms.
Semi gloss
A brighter shine that shows off grain and color. Suits formal rooms with lighter use.

Floor types, side by side

Gloved hands setting a new red oak strip board into place with a rubber mallet and tapping block beside

Solid hardwood

One piece of wood top to bottom, usually three quarters of an inch thick. Solid oak, maple, hickory and walnut can be sanded and refinished several times, which is why many floors installed generations ago are still in use. Solid wood is nailed to a wood base and likes rooms on or above ground level.

  • Can be refinished many times
  • Strip widths suit older rooms
  • Unfinished boards can be stained on site
Cross section of an engineered wood board: a real wood wear layer on a layered coreReal wood wear layerLayered coregrain crossed for stability

Engineered wood

A real wood top layer glued to a layered core. The core keeps the board steady when indoor air changes with the seasons, so engineered wood suits slabs, rooms over garages and sunrooms. A thicker top layer allows a future sanding; a thin one is cared for with recoats.

  • Steady over slabs
  • Wide planks without much movement
  • Glue down or floating installs
Quiet upstairs bedroom with a sloped ceiling and new oatmeal colored wall to wall carpet in morning light

Carpet

Cut pile carpet feels soft and plush, loop pile is tough and low, and patterned or cut and loop carpet hides footprints. A good pad under any of them adds comfort and helps the carpet keep its shape. Carpet is the quiet, warm choice for bedrooms and upper floors.

  • Softest floor underfoot
  • Cuts footstep noise between floors
  • Easy to change color room by room
Gloved hands pressing a large charcoal porcelain floor tile into combed thinset with white spacers in an entry hall

Porcelain and ceramic tile

Porcelain is dense and hard wearing, good for entries and busy kitchens. Ceramic is lighter and easier to cut, a fine pick for backsplashes and lighter use floors. Sizes range from small hex and subway to large format squares and long wood look planks.

  • Handles grit and boots
  • Many sizes and layouts
  • Grout color changes the whole look
Narrow staircase with new walnut tone oak treads, rounded nosing and white painted risers

Stair treads and nosing

Treads come in solid oak, maple and other species in standard depths, cut to each step on site. Nosing can be rounded, square or bullnose. Risers can match the wood or be painted, which keeps a narrow stair bright.

  • Matches the floors above and below
  • Rounded nosing is gentle underfoot
  • Painted risers add contrast

Material questions

Which floor is easiest to look after?

Porcelain tile and a well finished wood floor are both easy: sweep or vacuum often, and use a barely damp mop now and then. Carpet needs regular vacuuming and a deeper clean every so often.

Can I mix different floors in one house?

Yes, and most homes do. The trick is to plan where they meet. Doorways are the natural place for a change, with a slim wood or metal transition between floors.

Which wood species are most common?

Red and white oak are the most common by far, followed by maple, hickory and walnut. Older homes here often have heart pine or oak strip floors.

Can I see samples before I decide?

Yes. We bring samples to the measure visit, and for refinishing we can lay test patches of stain on your own floor.

Want to see it in your own light?

We bring samples of the tones and materials you like to the measure visit, so you can see them on your floor, next to your trim and walls.