Stair Treads and Nosing in Virginia
New wood stair treads, rounded nosing and riser covers for staircases that need to match a new floor or move on from worn carpet.

About this service
A staircase is the one place where the floors of a house meet each other, so it shows quickly when it does not match. We fit new wood treads with rounded nosing over the existing stair, add riser covers in wood or paint grade, and finish the landing so the run from the hall to the upper floor reads as one surface.
Each tread is measured on its own, because no two steps in an older house are exactly the same width or depth. Treads are cut to the stair, glued and fastened, and the nosing is shaped to the profile you choose. Where a stair meets the wall or a skirt board, the cut is scribed tight so there is no gap to fill.
Treads can be prefinished to match a floor we are installing, or left bare and stained on site to match the floor you already have. Many people pair the stairs with a refinished hall or a new floor upstairs so the whole path through the house is done at once.
Staircases in older row houses tend to be steep and narrow, with walls that lean a little and steps that have worn unevenly over the years. That is exactly why every tread is scribed by hand to its own step, and why we check the rise and run of each step so the finished stair feels even underfoot from bottom to top.
How the four stages run
Measure
We measure every step and the landing, and look at how the stair meets walls, skirts and railings.
Prepare
Old carpet, tack strip and staples come off, and the surface of each step is made flat and firm.
Install
Treads and nosing are cut to each step, glued and fastened, with riser covers fitted between them.
Finish
Treads are stained and coated to match where needed, and the landing meets the hall floor cleanly.
Good to know
- Each tread is cut to its own step
- Rounded nosing is easy on bare feet and socks
- Painted risers brighten a narrow stair
- A matching landing ties the stair to the hall
Questions people ask
What does stair tread work cover?
It covers the surfaces you see and walk on: treads, nosing, riser covers and the landing, all fitted over the stair you already have.
Can you match the stairs to my existing floor?
Yes. We can bring unfinished treads and stain them on site alongside a sample of your floor, adjusting the tone until the two sit well together.
What about the railings and balusters?
We work around the railing and balusters that are there, scribing each tread around the posts so the fit is clean.
How long are the stairs out of use?
A typical straight stair is fitted in a day or two. If the treads are stained and coated on site, plan a little more time for the finish to set, and we will tell you how to get up and down safely in between.
Planning stair treads and nosing?
Send the rooms and a few words about the floor today. We set up a measure and put the plan in writing.

